Regency Gas Insert E21-NG3 Manuel d'utilisateur

WARNING: If the information in these instructions are not followed exactly, a fi re or explosion may result causing property damage, personal injury

10 Regency® E21-3 Gas Fireplace InsertWIRING DIAGRAMSINSTALLATIONCAUTION: Label all wires prior to disconnection when servicing controls. Wiring er

11Regency® E21-3 Gas Fireplace InsertNote: Do not operate unit if fl ue connector is not fastened in original position.FLUE CONNECTOR INSTALLATION 1)

12 Regency® E21-3 Gas Fireplace InsertGAS PIPE PRESSURE TESTINGThe appliance must be isolated from the gas supply piping system by closing its indivi

13Regency® E21-3 Gas Fireplace InsertTEST FOR FLUE SPILLAGEA " spillage" test must be made before the installed unit is left with the custom

14 Regency® E21-3 Gas Fireplace InsertLOG SET INSTALLATIONLog kit (Part # 533-930) contains the following pieces: a) 27-23 Back Center Log b) 27-24

15Regency® E21-3 Gas Fireplace Insert6) Fit log 27-26 into the pins on the front right side of the burner.5) Rest the top of log 27-25 in the notch

16 Regency® E21-3 Gas Fireplace Insert8) Fit log 27-28 into the pin on the left side of the burner.9) Fit the left end of log 27-29 into the pin on

17Regency® E21-3 Gas Fireplace InsertCompleted Log Set Installation27-2311) Place embers along the front of the burner as shown. Ensure not to cover

18 Regency® E21-3 Gas Fireplace InsertDiagram 4Diagram 56) Connect the ON/OFF switch wires by taking the black and red wires with the female ends an

19Regency® E21-3 Gas Fireplace InsertFLUSH GLASS1) Install the bottom glass trim onto the glass support.2) Slide the glass into the bottom glass tri

2 Regency® E21-3 Gas Fireplace InsertCONGRATULATIONS!You are the owner of a state-of-the-art Gas Insert by:FPI FIREPLACE PRODUCTS INTERNATIONAL LTD.T

20 Regency® E21-3 Gas Fireplace InsertBAY LOUVERS1) Install top louver by sliding the two bracket clips into the brackets located on top of the bay

21Regency® E21-3 Gas Fireplace InsertConversion Kit# 534-969 from NG to LPTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO

22 Regency® E21-3 Gas Fireplace Insert17) Verify that if the conversion is from NG to LPG, the screw must be re-assembled with the red o-ring visib

23Regency® E21-3 Gas Fireplace InsertInstaller Notice:These instructions must be left with the appliance.37) Check for gas leaks.38) Check inlet and

24 Regency® E21-3 Gas Fireplace InsertFULL SCREEN DOORS1) Hold the full screen door up against the unit in order to make the following wire connecti

25Regency® E21-3 Gas Fireplace Insert6) Place Bottom Frame near hinge. Flip hinge over Bottom Frame and secure with 3 screws each.Bottom FrameHinge L

26 Regency® E21-3 Gas Fireplace InsertThermostat Wire TableCAUTIONDo not wire millivolt wall thermostat wiresto 120V wire.WALL SWITCH1) Run the wire

27Regency® E21-3 Gas Fireplace InsertFINAL CHECKBefore leaving this unit with the customer, the installer must ensure that the appliance is fi ring cor

28 Regency® E21-3 Gas Fireplace InsertOPERATING INSTRUCTIONSCOPY OF LIGHTING PLATE INSTRUCTIONS LIGHTING INSTRUCTIONSTO TURN OFF GAS APPLIANCEGas In

29Regency® E21-3 Gas Fireplace InsertMAINTENANCE INSTRUCTIONS1) Always turn the gas valve to off before cleaning. For relighting, refer to lighting i

3Regency® E21-3 Gas Fireplace InsertTABLE OF CONTENTSSAFETY LABELSerial No. Decal ...4REQUIRE

30 Regency® E21-3 Gas Fireplace InsertREMOVING VALVE ASSEMBLY1) Disconnect the power.2) Shut off the gas.3) Remove top and bottom louvers.4) Rem

31Regency® E21-3 Gas Fireplace InsertPARTS LISTMAIN ASSEMBLY Part # Description Part # Description 530

32 Regency® E21-3 Gas Fireplace InsertBURNER ASSEMBLY & LOG SET Part # Description 533-574/P Valve Assembly-

33Regency® E21-3 Gas Fireplace InsertPARTS LISTBAY & FLUSH FRONT ASSEMBLY Part # Description Pa

34 Regency® E21-3 Gas Fireplace InsertFACEPLATE ASSEMBLY Part # Description 91) 910-330 Fan Speed Cont

35Regency® E21-3 Gas Fireplace InsertWARRANTYRegency Fireplace Products are designed with reliability and simplicity in mind. In addition, our interna

Installer: Please complete the following informationDealer Name & Address: _______________________________________________________________________

4 Regency® E21-3 Gas Fireplace InsertSAFETY LABELThis is a copy of the label that accompanies each Regency® Gas Insert. We have printed a copy of the

5Regency® E21-3 Gas Fireplace InsertREQUIREMENTS 5.08: Modifications to NFPA-54, Chapter 10(2) Revise 10.8.3 by adding the following additional requir

6 Regency® E21-3 Gas Fireplace InsertIMPORTANT MESSAGE SAVE THESE INSTRUCTIONSThe Regency® Gas Fireplace must be installed in accordance with these

7Regency® E21-3 Gas Fireplace InsertINSTALLATION POLICY FOR SOLID FUEL BURNING & FACTORY BUILT FIREPLACESThe Regency® E21 may be installed and ven

8 Regency® E21-3 Gas Fireplace InsertCLEARANCES TO COMBUSTIBLESINSTALLATION The minimum clearance from the side of the appliance to a combustible sid

9Regency® E21-3 Gas Fireplace InsertHIGH ELEVATIONThis unit is approved in Canada for altitude 0 to 4500 ft. (CAN/CGA 2.17-M91) with the orifi ce suppl