Regency FireGenie Manuel d'utilisateur télécharger pdf (Page 2)

The FireGenie

Remote Control is tested safe when installed in accordance with this installation

manual. It is your responsibility to read all instructions before starting installation and to follow

these instructions carefully during installation.

The FireGenie

Remote Control is carefully engineered and MUST be installed only as speciﬁ ed. If

you modify it or any of its components, you may possibly cause a ﬁ re hazard.

The FireGenie

Remote Control MUST be installed by a qualiﬁ ed installer.

FCC Requirements

Warning: Changes or modiﬁ cations to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment. This equipment has been

tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 to the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiver antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio TV technician for help.

Canadian Equipment Requirements

This digital apparatus does not exceed the (class A/class B)* limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the

following two conditions; (1) this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired operation of the device.

All wiring should be done by a qualiﬁ ed electrician and shall be in compliance with local codes and

with the National Electric Code ANSI/NFPA No. 70-current (In the United States), or with the CSA

C22.1 Canadian Electric Code (in Canada).

1 2 3 4 5 6 7 ... 23 24

Pas de commentaire

Regency FireGenie Manuel d'utilisateur Page 2